Appliance Repair Corinth

Washing machine repair

Washer Repair in Corinth, TX

Front-load or top-load, stacked in a hall closet or side by side with the dryer: a technician comes out, finds why the washing machine stopped doing its job and talks you through the fix before starting.

Book a visit
88% fixed on the first visit
Front-load washing machine in a Corinth, TX laundry room

Symptoms

What a failing washer looks like

Six faults behind most washing machine calls. If yours matches one, say so when you book.

Won't drain

The cycle ends and the clothes sit in gray water.

Won't spin

Laundry comes out dripping, and the drum barely turns at the end.

Leaking

A puddle shows up under the front edge or behind the machine after a wash.

Banging during spin

The washer walks across the floor or thumps loud enough to hear from the next room.

Door or lid stays locked

The cycle is over, the lock light stays on and the door won't open.

Stops mid-cycle

The display lights up, then the washer quits halfway, often with an error code.

Typical causes

Three common causes, and how we check them

Clogged drain pump or filter

Socks, coins and hair ties collect in the pump and keep the water from leaving the tub.

How we check it

We open the pump housing, clear it and confirm the motor gets power and turns freely.

Worn shocks, springs or bearings

They let the tub swing too far under load. That causes the banging and, over time, leaks at the tub seal.

How we check it

We test the suspension by hand with the drum empty and listen to the bearings at spin speed.

Faulty lid switch or door lock

The control board won't spin or unlock the door until it gets a clean signal from the lock.

How we check it

We check the lock assembly for continuity and confirm the board is sending it power.

How we diagnose

How we track down a washer fault

Diagnostic checklist

  • Reads the error code and, on models that keep one, the fault history saved in the control board
  • Runs a short test cycle to see and hear where it fails
  • Checks the inlet valves, fill hoses and incoming water pressure
  • Inspects the pump, the drain hose and the standpipe behind the washer
  • Looks at the tub seal and bearings before recommending a repair on an older machine
Call and Request Washer Service

1,600+

repairs completed

88%

finished on the first visit

35+

brands we work on

5 years

of house calls in Corinth

  • Licensed & insured
  • OEM parts
  • 90-day warranty

From a recent visit

Fairview West

LG front-load washer

Problem: Stopped mid-drain with an OE code.

Repair: A coin and a hair tie had jammed the drain pump. Cleared it and installed a new OEM pump.

Useful tips

Quick checks before you book

Check these first

  • Close the lid or door firmly until it clicks. A lid that isn't seated keeps many washers from starting or spinning.
  • On a front-loader, empty the drain filter behind the small panel at the bottom front. Unplug the washer first and keep towels and a shallow pan ready.
  • Make sure both water valves behind the washer are fully open and the hoses aren't kinked.
  • Write down any error code on the display. It tells the technician where to start.

Keep it running longer

  • Leave a front-loader's door open between washes so the rubber gasket can dry.
  • Use HE detergent and measure it. Extra suds make the machine work harder and can set off drain errors.
  • Replace rubber fill hoses about every five years, or switch to braided stainless steel.
  • Split bulky loads like comforters when the drum is packed to the top.

Brands

Washer brands we work on

Front-loaders from LG and Samsung, top-loaders from Whirlpool and Maytag, and Speed Queen machines built for heavy use. These eight come up most often.

Service area

Washer repair across Corinth

Laundry rooms off the garage, upstairs closets with a stacked pair, a washer tucked beside the back door: we come to all of them.

  • Oakmont
  • Provence
  • Terrace Oaks
  • Lake Sharon Estates
  • Parkside Farms
  • Meadows North
  • Post Oak Crossing
  • Fairview West
  • Ashford Park
  • Amity Village

Something else acting up as well? Our page on appliance repair in Corinth, TX covers every machine we work on.

Main ZIP code

76210

Neighborhood not listed? to check the address.

Questions

Washer repair FAQ

Should I keep using a washer that's leaking?

Better not. Turn off the water valves behind it and wait for the visit. A small leak at the pump or a hose can turn into a wet floor on the next cycle.

Is a washer that walks across the floor dangerous?

It usually points to an unbalanced load, worn shocks or an uneven floor. Try a smaller load first; if it still shakes, the suspension needs a look.

Do you repair stacked washer and dryer units?

Yes. Mention the stacked setup when you book, since these units often have to be pulled out of a closet.

Repair or replace an older washer?

It depends on the fault and the condition of the machine. A pump, a lock or a belt is usually worth fixing; a failed tub bearing on an old washer may not be. You'll hear which one it is before any work starts.

Book a visit

Book washer repair in Corinth, TX

Tell us the brand and whether it's a front-load or top-load model. We’ll get in touch to set a time between 7 am and 11 pm.

  • Licensed & insured technicians
  • OEM parts and a 90-day warranty
  • You pay once the work is done